CWB

• Continuous Pass-Through Wire Mesh Conveyor Style Machine

• Continuously Variable Pass-Through Speed

• High Volume Air Abrasive Recovery System at Exit

• Accommodates Work pieces up to 33.5 ” Wide x 11.8 “ High

• Flat Floor Installation – No Pits

The CWB series of machines is a pass through wire mesh conveyor type machine for the blasting of small to medium sized work pieces.  Work pieces with overall dimensions and weight not exceeding the specifications can be blasted in continuous operation.  Work pieces are placed onto a steel wire mesh conveyor and transported through the blast cabinet where blast wheels are located above and below the conveyor to ensure that all work piece surfaces are exposed to the blast stream.  After blasting, the work pieces are dropped off of the end of the conveyor into a receiving container or onto another conveyor.  Optionally, a kickoff roller can be placed at the end of the conveyor to assist in the removal of the work pieces.

The pass-through openings in the entry and exit vestibules are shrouded by wear resistant rubber curtains to limit the escape of stray abrasive.   The exit vestibule is fitted with a high pressure fan powered blowing system for removing and recovering residual abrasive from the blasted work pieces.  This machine is designed to allow for installation on a flat floor, not requiring any pits or pockets.

All OMSG shot blast machines include an integral abrasive recovery and cleaning system.  After passing through the blast wheel, the abrasive is collected, separated from the resulting dust and other contaminants, and then stored in a hopper, ready for reuse.  Collected contaminants are stored in a separate hopper for periodic disposal.   

All machines utilize replaceable highly wear resistant materials in critical locations.  All machine control systems are pre-piped and pre-wired.  All machine dust exhaust ports are pre-piped to a central collection point, ready to be connected to an external dust collector or optionally, a fully integrated dry cartridge type dust collector can be provided.